Pbyp (Picture By Picture) - Dukane 9137WU-RJ User Manual

PbyP (Picture by Picture)

The PbyP is a function to display two different picture signals on a screen that is
split in two areas for each signal. Some of functions can be used with the same
operation as it for the normal mode (not in the PbyP mode). There are some
operations available only in the PbyP mode.
Starting the PbyP
Press the PbyP button on the remote control, then
the PbyP function will be started. To quit the PbyP
mode, press the button again.
Showing the setting information
The setting information will be appeared for several
seconds when the PbyP function is started. It shows
the input signal information for each area. Also, there
will be a yellow frame and speaker mark with one of the area that is the main area
where most of operations are effective. The information can be appeared using
the cursor buttons ▲/▼/◄/► when the setting information is not on the screen.
Changing the main area
Most of operations are effective for the main area
only. Also the audio input signal paired with the
picture input signal for the main area is assigned as
the audio output signal. The main area can be changed using the
cursor buttons ◄/► when the setting information is on the screen.
Changing the picture input signal
Press the INPUT, RGB or VIDEO button while in
the PbyP mode, the menu to select the input signal
will be appeared. Choose a signal using the cursor
buttons ▲/▼. If you want to change the signal in the sub
area, switch the main area using the cursor buttons ◄/► first.
Displaying the same signal on the both areas is not allowed.
For other combinations of the input signal, refer to the right
table. Any combinations marked with X can not be selected.
Using the PbyP SWAP function
Press the MY BUTTON1/2 assigned the PbyP SWAP
(49). The position of the both area is exchanged
without any setting change.
NOTE
•For some signals, it may not be displayed correctly in the PbyP mode,
even if it can be displayed properly in the normal mode.
normal mode
main area
25
Operating
PbyP mode
setting information
main area
sub area
<signal combination>
Main
Sub
RGB1 0 0 0 0 0
RGB2 0 0 0 0 0
HDMI 0 0 0 X X
Component 0 0 0 0
Scart RGB 0 0 X X
S-Video 0 0 X 0 X
Video 0 0 X 0 X X
0
0
X
0
X
X