Dukane 9137WU-RJ Technical Manual

Hide thumbs Also See for 9137WU-RJ:

Advertisement

Quick Links

Projector
9
137WU-RJ
User's Manual – Operating Guide Technical
Example of computer signal
Resolution (H x V) H. frequency (kHz) V. frequency (Hz)
720 x 400
640 x 480
640 x 480
640 x 480
640 x 480
800 x 600
800 x 600
800 x 600
800 x 600
800 x 600
832 x 624
1024 x 768
1024 x 768
1024 x 768
1024 x 768
1152 x 864
1280 x 960
1280 x 1024
1280 x 1024
*1280 x 1024
*1600 x 1200
1280 x 768
1680 x 1050
1280 x800
1920 x1200
NOTE
• Be sure to check jack type, signal level, timing and resolution
before connecting this projector to a computer.
• Some computers may have multiple display screen modes. Use of some of
these modes will not be possible with this projector.
• Depending on the input signal, full-size display may not be possible in some
cases. Refer to the number of display pixels above.
• Although the projector can display signals with resolution up to WUXGA
(1920x1200), the signal will be converted to the projector's panel resolution
before being displayed. The best display performance will be achieved if the
resolutions of the input signal and projector panel are identical.
• Automatic adjustment may not function correctly with some input signals.
• The image may not be displayed correctly when the input sync signal is a
composite sync or a sync on G.
• The HDMI input does not support the signals marked with *.
37.9
31.5
37.9
37.5
43.3
35.2
37.9
48.1
46.9
53.7
49.7
48.4
56.5
60.0
68.7
67.5
60.0
64.0
80.0
91.1
75.0
47.7
65.3
83.5
74.0
1
Rating
85.0
VESA
59.9
VESA
72.8
VESA
75.0
VESA
85.0
VESA
56.3
VESA
60.3
VESA
72.2
VESA
75.0
VESA
85.1
VESA
74.5
60.0
VESA
70.1
VESA
75.0
VESA
85.0
VESA
75.0
VESA
60.0
VESA
60.0
VESA
75.0
VESA
85.0
VESA
60.0
VESA
60.0
VESA
60.0
VESA
60.0
VESA
60.0
VESA
Signal mode
TEXT
VGA (60Hz)
VGA (72Hz)
VGA (75Hz)
VGA (85Hz)
SVGA (56Hz)
SVGA (60Hz)
SVGA (72Hz)
SVGA (75Hz)
SVGA (85Hz)
Mac 16" mode
XGA (60Hz)
XGA (70Hz)
XGA (75Hz)
XGA (85Hz)
1152 x 864 (75Hz)
1280 x 960 (60Hz)
SXGA (60Hz)
SXGA (75Hz)
SXGA (85Hz)
UXGA (60Hz)
W-XGA (60Hz)
WSXGA+(60Hz)
1280 x 800 (60Hz)
W-UXGA(60Hz)
Reduced Blanking
403-9137WU-RJ-Tech-00

Advertisement

Table of Contents
loading

Summary of Contents for Dukane 9137WU-RJ

  • Page 1 • Automatic adjustment may not function correctly with some input signals. • The image may not be displayed correctly when the input sync signal is a composite sync or a sync on G. • The HDMI input does not support the signals marked with *. 403-9137WU-RJ-Tech-00...
  • Page 2 Initial set signals Initial set signals The following signals are used for the initial settings. The signal timing of some computer models may be different. In such case, adjust the items V POSITION and H POSITION in the IMAGE menu. Back porch (B) Front porch (D) Back porch (b)
  • Page 3 Connection to the ports Connection to the ports RGB1 HDMI VIDEO AUDIO IN1 RGB2 AUDIO IN2 S-VIDEO AUDIO OUT REMOTE CONTROL AUDIO IN3 AUDIO IN4 CONTROL AC IN RGB 1, RGB OUT D-sub 15pin mini shrink jack • Video signal: RGB separate, Analog, 0.7Vp-p, 75Ω...
  • Page 4: Component Video

    Connection to the ports (continued) RGB1 HDMI VIDEO AUDIO IN1 RGB2 AUDIO IN2 S-VIDEO AUDIO OUT REMOTE CONTROL AUDIO IN3 AUDIO IN4 CONTROL AC IN COMPONENT VIDEO RCA jack x3 • System: 480i@60, 480p@60, 576i@50, 720p@50/60, 1080i@50/60,1080p@50/60 Port Signal Component video Y, 1.0±0.1Vp-p, 75Ω terminator with composite sync Component video C , 0.7±0.1Vp-p, 75Ω...
  • Page 5: Audio Out

    Connection to the ports (continued) RGB1 HDMI VIDEO AUDIO IN1 RGB2 AUDIO IN2 S-VIDEO AUDIO OUT REMOTE CONTROL AUDIO IN3 AUDIO IN4 CONTROL AC IN AUDIO IN 1, AUDIO IN 2 Ø3.5 stereo mini jack • 500 mVrms 47kΩ terminator AUDIO IN 3 L, AUDIO IN 4 RCA jack x2...
  • Page 6 Connection to the ports (continued) RGB1 HDMI VIDEO AUDIO IN1 RGB2 AUDIO IN2 S-VIDEO AUDIO OUT REMOTE CONTROL AUDIO IN3 AUDIO IN4 CONTROL AC IN USB B type jack Signal 1 +5V 2 - Data 3 + Data 4 Ground RJ-45 jack Signal Signal...
  • Page 7: Connecting The Cable

    RS-232C Communication RS-232C Communication CONTROL port RS-232C cable (Cross) RS-232C port of the projector of the computer - (1) (1) CD RD (2) (2) RD TD (3) (3) TD - (4) (4) DTR GND (5) (5) GND - (6) (6) DSR RTS (7) (7) RTS CTS (8)
  • Page 8 RS-232C Communication (continued) Requesting projector status (Get command) (1) Send the request code Header + Command data (‘02H’+‘00H’+ type (2 bytes)+‘00H’ +‘00H’) from the computer to the projector. (2) The projector returns the response code ‘1DH’+ data (2 bytes) to the computer. Changing the projector settings (Set command) (1) Send the setting code Header + Command data (‘01H’+‘00H’+ type (2 bytes) + setting code (2 bytes)) from the computer to the projector.
  • Page 9: Communication Port

    Command Control via the Network Command Control via the Network Communication Port The following two ports are assigned for the command control. TCP #23 TCP #9715 Command Control Settings Configure the following items form a web browser when command control is used. Port Settings Click the [Enable] check box to open [Network Port open...
  • Page 10: Command Format

    Command Control via the Network (continued) Command Format [TCP #23] 1. Protocol Consist of header (7 bytes) + command data (6 bytes) 2. Header BE + EF + 03 + 06 + 00 + CRC_low + CRC_high CRC_low: Lower byte of CRC flag for command data CRC_high: Upper byte of CRC flag for command data 3.
  • Page 11 Command Control via the Network (continued) Decreasing the projector setting value (Decrement command) (1) The PC sends the following decrement code to the projector. Header + Command data (‘05H’ + ‘00H’ + type (2 bytes) + ‘00H’ + ‘00H’) (2) The projector decreases the setting value on the above setting code. (3) The projector returns the response code ‘06H’...
  • Page 12: Reply Data

    Command Control via the Network (continued) 7. Reply Data The connection ID (the data is same as the connection ID data on the sending data format) is attached to the Network control commands reply data. ACK reply: ‘06H’ + ‘xxH’ NAK reply: ‘15H’...
  • Page 13 RS-232C Communication / Network command table RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code Power TURN OFF BE EF 06 00 2A D3 01 00 00 60 00 00 TURN ON BE EF 06 00 BA D2 01 00...
  • Page 14 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code GAMMA #1 DEFAULT BE EF 06 00 07 E9 01 00 A1 30 20 00 #2 DEFAULT BE EF 06 00 97 E8 01 00 A1 30 21 00 #3 DEFAULT...
  • Page 15 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code COLOR TEMP #1 HIGH BE EF 06 00 0B F5 01 00 B0 30 03 00 #2 MID BE EF 06 00 9B F4 01 00 B0 30 02 00...
  • Page 16 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code MY MEMORY Load BE EF 06 00 0E D7 01 00 14 20 00 00 BE EF 06 00 9E D6 01 00 14 20 01 00 BE EF 06 00...
  • Page 17 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code COLOR SPACE AUTO BE EF 06 00 0E 72 01 00 04 22 00 00 BE EF 06 00 9E 73 01 00 04 22 01 00 SMPTE240 BE EF...
  • Page 18 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code AUTO KEYSTONE V Execute BE EF 06 00 E5 D1 06 00 0D 20 00 00 EXECUTE AUTO KEYSTONE V TURN OFF BE EF 06 00 EA D1 01 00...
  • Page 19 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code ACTIVE IRIS TURN OFF BE EF 06 00 0B 22 01 00 04 33 00 00 THEATER BE EF 06 00 CB 2F 01 00 04 33 10 00 PRESENTATION...
  • Page 20 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code MONITOR OUT - RGB1 BE EF 06 00 2A F7 01 00 BF 20 00 00 STANDBY RGB2 BE EF 06 00 EA F5 01 00 BF 20 04 00...
  • Page 21 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code BASS - RGB1 BE EF 06 00 0D FB 02 00 80 20 00 00 Increment BE EF 06 00 6B FB 04 00 80 20 00 00 Decrement...
  • Page 22 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code AUDIO - COMPONENT Set TURN OFF BE EF 06 00 32 DD 01 00 35 20 00 00 AUDIO1 BE EF 06 00 A2 DC 01 00 35 20 01 00...
  • Page 23 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code LANGUAGE ENGLISH BE EF 06 00 F7 D3 01 00 05 30 00 00 FRANCAIS BE EF 06 00 67 D2 01 00 05 30 01 00 DEUTSCH BE EF...
  • Page 24 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code TEMPLATE TEST PATTERN BE EF 06 00 43 D9 01 00 22 30 00 00 DOT-LINE1 BE EF 06 00 D3 D8 01 00 22 30 01 00 DOT-LINE2...
  • Page 25 RS-232C Communication / Network command table Command Data Names Operation Type Header Action Type Setting Code MY BUTTON-1 RGB1 BE EF 06 00 3A 33 01 00 00 36 00 00 RGB2 BE EF 06 00 FA 31 01 00 00 36 04 00 HDMI...
  • Page 26 02 35 00 00 IMAGE-2 Delete MY IMAGE Execute BE EF 06 00 C9 C2 06 00 03 35 00 00 IMAGE-3 Delete MY IMAGE Execute BE EF 06 00 BD C3 06 00 04 35 00 00 IMAGE-4 Delete 403-9137WU-RJ-Tech-00...

Table of Contents