Adjusting The Position; Correcting Distortion - Dukane 9137WU-RJ User Manual

Adjusting the position

1.
Press the POSITION button on the remote control when no
menu is indicated.
The "POSITION" indication will appear on the screen.
2.
Use the ▲/▼/◄/► cursor buttons to adjust the picture position.
When you want to reset the operation, press the RESET
button on the remote control during the operation.
To complete this operation, press the POSITION button
again. Even if you do not do anything, the dialog will
automatically disappear after a few seconds.
● When this function is performed on a video signal, s-video signal or
component video signal, some image such as an extra-line may appear at
outside of the picture.
● When this function is performing on a Video signal, S-Video signal, or
component signal of 480i@60 or 576i@50 input the range of this adjustment
depends on the OVER SCAN in IMAGE Menu (32). It is not possible to
adjust when the OVER SCAN is set to 10.

Correcting distortion

1.
Press the KEYSTONE button on the remote control. A
dialog will appear on the screen to aid you in correcting
the distortion. Even if you do not do anything, the dialog
will automatically disappear after a few seconds.
2.
Use the ▲/▼ cursor buttons to select AUTO, MANUAL or PERFECT FIT
operation, and press the ► button to perform the following.
(1) AUTO executes automatic vertical keystone correction.
● When V:INVERT or H&V:INVERT is selected to the MIRROR item in the
SETUP Menu, if the projector screen is inclined or angled downward, this
function may not work correctly.
● When the zoom adjustment is set to the TELE (telephoto focus), this
function may be excessive. This function should be used when the zoom
adjustment is set to the full WIDE (wide-angle focus) whenever possible.
● When the projector is placed on the level (about ±3°), this function may not
work.
● When the projector is inclined to near ±30 degree or over, this function may
not work well.
● When the vertical lens shift is not set fully upward, this function may not
work well.
● When the horizontal lens shift is not set to the center, this function may not
work well.
21
BLANK LASER
Operating
ASPECT
PUSH ENTER
PAGE UP PAGE DOWN
ESC MENU RESET
LASER
POSITION AUTO INDICATOR PbyP
STANDBY/ON VIDEO RGB
MY BUTTON VOLUME
MAGNIFY
1
ON
+
MY SOURCE/
DOC.CAMERA
OFF 2
-
SEARCH
FREEZE KEYSTONE MUTE
BLANK LASER
ASPECT
ENTER
PUSH
PAGE UP PAGE DOWN
ESC MENU RESET
PbyP
POSITION AUTO
MAGNIFY MY BUTTON VOLUME
ON 1
+
2
OFF
-
FREEZE KEYSTONE MUTE