Product Specifi C & Important Safety Information; Fireplace Certifi Cation; Glass Specifi Cations; Non-Combustible Materials - Heatilator C40 Installation Manual

1
Product Specifi c & Important Safety Information
A. Fireplace Certifi cation
This fi replace system has been tested and listed in ac-
cordance with UL127 and ULC-S610-M87 and (UM)84-
HUD standards for installation and operation in the United
States and Canada as described in this manual.
Check with your local building code agency before you
begin your installation to ensure compliance with local
codes, including the need for permits and follow-up in-
spections. Be sure local building codes do not supersede
UL specifi cations and always obtain a building permit so
that insurance protection benefi ts cannot be unexpectedly
cancelled.
Heatilator is a registered trademark of Hearth & Home
Technologies.
Model: Constitution EPA Certifi ed
Woodburning Fireplace
Laboratory: OMNI Test Laboratories, Inc.
Report No: 061-S-50-2
Type:
Wood Fireplace
Standard: UL127 and ULC-S610-M87 and
(UM) 84-HUD, Manufactured
Home Approved.
EPA# and Original Date:
EPA Certifi ed:
Effi ciency:
BTU Output
with EPA test fuel:
with Cord Wood:
Heating Capacity:
Chimney Size:
HHT
DuraVent
Max Wood Length:
Fuel:
Shipping Weight:
Firebox Size
4
Heatilator • C40 Constitution • 480-2340 Installation Manual • Rev B 01-29-13
#571 4-1-03
3.25 grams per
hour
up to 77%
51,400 / hr.
70,000 / hr.
up to 3,500 sq ft
8 inches
SL300 Series
DuraPlus
24 inches
Cord Wood
650 lbs
3.4 cubic feet
B. Glass Specifi cations
This fi replace is equipped with 5 mm ceramic glass. Re-
place glass only with 5 mm ceramic glass. Please contact
your dealer for replacement glass.
NOTICE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL127, (UM)
84-HUD and NFPA211 in the U.S.A. and the ULC 610-M87
and CAN/CSA-B365 Installation Codes in Canada.
WARNING! Risk of Fire!
disclaims any responsibility for, and the warranty and agen-
cy listing will be voided by the following actions.
DO NOT:
• install or operate damaged fi replace
• modify fi replace
• install other than as instructed by Hearth & Home
Technologies
• operate the fireplace without fully assembling all
components
• overfi re
• install any gas log set
• install any component not approved by Hearth & Home
Technologies
• install parts or components not Listed or approved
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
C. Non-Combustible Materials
• Materials which will not ignite and burn, composed of
any combination of the following:
- Steel
- Brick
- Concrete
- Glass
• Materials reported as passing ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace at 750° C
D. Combustible Materials
• Materials made of or surfaced with any of the following
materials:
- Wood
- Plant fi bers
- Plywood/OSB
• Any material that can ignite and burn; fl ame proofed or
not, plastered or un-plastered
Hearth & Home Technologies
- Iron
- Tile
- Slate
- Plasters
- Compressed paper
- Plastic
- Sheet rock (drywall)