Pc Connection - Panasonic Digital Palmcorder PalmSight PV-DV100-K Operating Instructions Manual

PHOTOVU Link Driver
An image stored in the DV Tape can be transferred to your PC (Personal Computer).
System Requirements for PHOTOVU LINK Driver
• IBM PC/AT or compatible.
® ®
• Intel Pentium Processor
• Microsoft Windows
• RAM: 16 MB or more
• 2 MB minimum available hard disk
space.
• 256 colour monitor (full colour
recommended).
Connection
1
Turn off your PC.
2
Connect the Digital Video Camcorder to your PC (Windows) using
the RS-232C PC connecting cable (supplied).
• Before connecting the Palmcorder to the PC, make sure the PC
power is off to insure that images are transferred properly.
3
Turn on your PC.
4
Set the Palmcorder POWER to VCR.
Note
• For extended periods of use, it is recommended to use the AC Adaptor
as a power source.
• Refer to the PC or Windows manual to identify which COM port is to be
used for connection.
100-K.53-56.p65
® 95 or Windows ® 98
To PC Connector
53

PC Connection

• 3.5 inch 1.44 MB floppy disk drive
(for installation).
• RS-232C serial port (D-Sub 9-pin).
An adaptor (D-Sub 9-pin male to a
D-Sub female) is required for a D-
Sub 25-pin.
• Mouse or other pointing device.
4
2
PC Connecting
Cable for Windows
(Supplied)
00/06/14, 11:57
RS-232C
(D-Sub 9-pin)
(Default is COM1.)
53