Installing The Mixer/Throttle Assembly - Daewoo G420E Service Manual

Installing the
Mixer/Throttle Assembly
13
(2.2 N•m)
15
17
(8.6 N•m)
16
4
7
6
(4.2
8
N•m)
5
(0.8 N•m)
(1) GASKET-INTAKE MANIFOLD
(2) ADAPTER-INTAKE MANIFOLD (3) BOLT-ADAPTER
(4) BRACKET-TMAP (5) BOLT-TMAP BRACKET
(6) TMAP SENSOR (7) WASHER-TMAP MTG
(8) BOLT-TMAP MTG (9) GASKET-ITB(32MM)
(10) ITB(32MM) (11) O-RING (12) APOLLO ADAPTER-ITB
(13) FITTING (14) PLUG (15) BOLT-APOLLO ADAPTER
(16) WASHER-ITB (17) BOLT-ITB
(18) MIXER(CA55) (19) FITTING (20) AIR HORN ADAPTER,
(21) WASHER-AIR HORN (22) BOLT-AIR HORN,
(23) FITTING-VENTILATION (24) O-RING SPACER
The mixer/throttle assembly consists of a manifold
adapter, electronic throttle, mixer-throttle adapter and
air horn adapter. The manifold adapter is designed to
mount the mixer/throttle assembly to a two-bolt intake
manifold. The air horn adapter allows the intake hose
from the air cleaner to be attached to the mixer air
intake, along with the vent line from the engine PCV
valve.
Tier
G420E/G424E
22 (2.2 N•m)
21
23
20
18
12
14
11 24
10
3
(41.6
N•m)
2
1
INTAKE
MANIFOLD
LP Engine
Figure M15
19
1. Align the Mixer-Throttle Adapter gasket between
the mixer and the throttle adapter (Figure M15),
and then attach the mixer to the adapter using the
four tamper-resistant retaining screws.
9
CHECK VALVE
Figure M16
Figure M17
2. Tighten the four tamper-proof retaining screws to
the specified torque (Figure M17).
75
CAUTION
The mixer must be installed with the idle
port aligned with the idle port in the
adapter, and the mixer check valve
aligned with the valve recess in the
adapter to operate properly (Figure M16).
Test And Adjustments
IDLE PORT