Table of Contents
Advertisement
Step 15.
Test remote control range.
Stand approximately 50 feet from the vehicle and use the remote control to arm and disarm the system.
n
The IntelliGuard 7000 will re spond with the pre vi ously noted in di ca tions for arm ing and dis arm ing. If not:
Re po si tion the external receiver as high as possible high up un der the dash, or as high as possible along side the windshield
o
pillar and as far as pos si ble from heavy wire looms and metal. Rotate the external receiver 90 degrees and re-test.
Make sure that the re mote con trol bat tery meas ures at least 11 volts while trans mit ting.
o
Make sure that the volt age at the con trol unit be tween the 5- amp fused power line and each of the two ground lines
o
meas ures at least 12.0 volts when triggered (if less, make sure both chas sis grounds are solid; if the grounds are solid, the
ve hi cle battery may need charg ing, serv ic ing or re place ment).
Make sure that no accessories have been tapped in to the solid RED or solid BLACK power wires.
o
Step 16.
Com plete and pro vide all nec es sary pa per work in clud ing:
User's Manual must be given to the customer.
n
Adhere the Clifford window decals to the vehicle's windows.
n
Step 17.
Dem on strate Ba sic Sys tem Operation
n
Remote Operations:
Arming/disarming and locking/unlocking
o
Panic Feature
o
Remote Valet Mode Activation
o
Dual-Zone Piezo Sensor Override
o
Accessory operation
o
n
AutoArming and AutoArming Bypass
Immobilization
n
Valet code entry
n
User-programming mode
n
In tel liGuard 7000/199
System Checklist & Troubleshooting (Continued)
15
Advertisement
Table of Contents
