1. Manuals
  2. Brands
  3. Directed Electronics Manuals
  4. Car Alarm
  5. 732T
  6. Owner's manual

Directed Electronics 732T Owner's Manual

Directed electronics state-of-the-art motorcycle security system owner's guide 732t
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Model 732T
Owner's Guide

Advertisement

Table of Contents
loading

Related Manuals for Directed Electronics 732T

Summary of Contents for Directed Electronics 732T

  • Page 1 Model 732T Owner's Guide...

  • Page 2: Limited Lifetime Consumer Warranty

    Contact your authorized dealer to obtain the ser- vice charge for your unit. These systems are a deterrent against possible theft. Directed Electronics, Inc. is not offering a guarantee or insuring against the theft of the automobile or its contents and disclaims any liability for the theft of the vehicle and/or its contents.
  • Page 3 This product warranty is automatically void if its date code or serial number is defaced, missing, or altered. This warranty will not be valid unless you have com- pleted the warranty card and mailed it to Directed Electronics, Inc. within 10 days after purchase to the address listed on the warranty registration card.

  • Page 4: Table Of Contents

    Quick Reference Guide (Removable) © 2000 Directed Electronics, Inc....... i .

  • Page 5: Standard Configuration

    Standard Configuration Disarm Panic Silent Mode Trunk Release Remote Valet Auxiliary Output © 2000 Directed Electronics, Inc.

  • Page 6: What Is Included

    It is also necessary to keep your receipt, which reflects that the product was installed by an authorized dealer. Make sure you receive the warranty card from your dealer. © 2000 Directed Electronics, Inc. ™ six-tone programmable siren...

  • Page 7: System Maintenance

    The Silent Mode, trunk release and Remote Valet functions are usu- ally controlled by Button II. (Silent Mode and Remote Valet work by pressing Button II for less than one second. Trunk release requires you to press Button II for 1.5 Seconds.) © 2000 Directed Electronics, Inc.

  • Page 8: Using Your System

    30 seconds after the ignition is turned off and the system "sees" you leave the vehicle by opening and closing a door. Whenever the system is in its 30 second passive-arming count- © 2000 Directed Electronics, Inc.

  • Page 9: Arming While Driving

    Your system can be armed while driving the vehicle! Simply press on your transmitter while the vehicle is running. The system will chirp once and then once more to indicate that the ignition ® signal. When trig- © 2000 Directed Electronics, Inc.

  • Page 10: Disarming

    To disarm with the transmitter during a trigger, press on your transmitter. The siren will stop sounding. Next press once more and the system will chirp four or five times (reporting the trigger) and disarm. © 2000 Directed Electronics, Inc.

  • Page 11: Disarming Without A Transmitter

    Silent Mode. This ensures that no chirps will be emit- ted by the siren in an area you want chirp-free. The system is still fully able to trigger. Only the Warn-Away response is defeated. DRW-35 ™ © 2000 Directed Electronics, Inc.

  • Page 12: Panic Mode

    3. Press and release the Valet switch within 10 seconds. The status LED will light solidly if you are entering Valet Mode, and it will go out if you are exiting Valet Mode. © 2000 Directed Electronics, Inc. on the remote transmitter DRW-35...

  • Page 13: Remote Valet

    Doors are covered by NPC differently: If the alarm is triggered by an open door for three full cycles (one-and-one-half minutes), the doors will be bypassed until the trigger ceases. ® © 2000 Directed Electronics, Inc.

  • Page 14: Diagnostics

    For example, if your car has interior light exit delay, and you arm the system before the interior light goes out, you may get Bypass Notification. Once the light goes out, howev- er, the doors are monitored normally. © 2000 Directed Electronics, Inc.

  • Page 15: Disarming Diagnostics

    Double Guard Shock Sensor Door switch trigger Optional hood or trunk pins or optional sensors Ignition trigger NOTE: If the Warn Away ® response is triggered, the LED will not report it. DEALER-INSTALLED OPTIONS ® © 2000 Directed Electronics, Inc.

  • Page 16: Code Hopping

    To re-synch the remote control simply press the arm/dis- arm button of the remote control several times within range of the vehicle. The alarm will automatically re-synch and respond to the transmitters normally. © 2000 Directed Electronics, Inc.

  • Page 17: Programming Options

    (one-half its normal armed rate) to indicate the AED arming cycle. 30 seconds later, the starter of the vehicle will be disabled. To start the car, you will need to arm the car © 2000 Directed Electronics, Inc.
  • Page 18 Any of these tones can be eliminated by your dealer, result- ing in a unique, easily identifiable siren sound. The siren chirps can be either full volume or 6 decibels quieter than the full alarm blast. © 2000 Directed Electronics, Inc.

  • Page 19: Glossary Of Terms

    Sensor. This sensor is contained within the control unit and designed to pick up impacts to the vehicle or glass. Siren: Noise generating device usually installed in the engine compartment of the vehicle. It is responsible for generating the © 2000 Directed Electronics, Inc.
  • Page 20 Zone: A zone is a separate input that the alarm can recognize as unique. Each input to the system is connected to a particular zone. Often two or more inputs may share the same zone. © 2000 Directed Electronics, Inc.

  • Page 21: Security & Convenience Expansions

    Power Trunk Release: One of the auxiliary outputs of the system can operate a factory power release for the vehicle’s trunk or hatch. (An optional relay may be required.) If the factory release is not power-activated, DEI's 522T trunk-release solenoid can often be added. © 2000 Directed Electronics, Inc.
  • Page 22 (Only for automatic- transmission, fuel-injected gasoline vehicles). Power Window Control: Automatic power window control is pro- vided with the 529T or 530T systems. © 2000 Directed Electronics, Inc.
  • Page 23 Notes © 2000 Directed Electronics, Inc.

  • Page 24: Quick Reference Guide (Removable)

    Using Remote Valet as you enter or exit the vehicle: Open any door. Press . Press light steady if you have entered Valet Mode, and it will go out if you exit- ed Valet Mode. © 2000 Directed Electronics, Inc. . Press again. The Status LED will...
  • Page 25 20 patents in the field of advanced electronic technology, DEI is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world. Call (800) 274-0200 for more information about our products and services.

Table of Contents