Error Message List - Konica Minolta bizhub C203 Operation Manual

Appendix
11 Appendix
11.1

Error message list

% If an error message appears, perform the corresponding operation described below.
Message
Unable to connect to the network.
The address for the communication
method cannot be selected since the
number of addresses has exceeded
the maximum allowed for broadcast-
ing.
Document could not be saved in user
box due to insufficient HDD capacity.
Check log.
The number of registered user boxes
has reached the max. allowance.
The number of documents saved in
the User Box has reached its maxi-
mum.
The number of programmed jobs has
reached the max. allowance. Wait un-
til a programmed job is completed.
bizhub C353/C253/C203 (FE2)
Cause and solution
A connection to the network could not be established. Check if the network
cable is correctly connected. In addition, check that the "Network Settings"
parameters in Administrator mode have been correctly specified.
For details on the network settings, refer to the User manual – Network Ad-
ministrator.
The number of destinations specified exceeds the number possible for a
broadcast transmission. Reduce the number of broadcast destinations, or
send the transmission in multiple batches.
The hard disk is full. Delete unnecessary data, and then try saving the data
again.
The number of user boxes that can be registered has reached the maximum
number possible. Delete unnecessary user boxes, and then try registering
new boxes again.
The number of documents that can be saved in a user box has reached the
maximum number possible. Delete unnecessary documents, and then try
saving the document again.
The number of jobs that can be programmed has reached the maximum
number possible. Wait until a job has been completed, or delete a current
job.
11
11-3