Toyota TNS300 RAV4 NAVIGATION SYSTEM Installation Instructions Manual page 18

RAV4 (A2)
Tab
12P
2
Tab
18P
12
8
-b
04-03
TX + TX -
WIRE SIDE VIEW
TX+ (yellow) 2
TX- (yellow/black)
Fig. 20
WIRE SIDE VIEW
Fig. 21
13
Driver side J/B
28P
Fig. 22
RAV4 (RHD) - 18
l l TX WIRE CONNECTION
4.
a) Turn the connector so that the wires
face you and the tab is on top.
b) Connect the TX(+) wire (yellow) of the
wire harness 2 to the wire of the third
position from the left side of the bottom
row.
c) Connect the TX(-) wire (yellow/black) of
the wire harness 2
fourth position from the left side of the
bottom row.
l l SPEED SENSOR CONNECTION
5.
a) Turn the connector so that the wires
face you and the tab is on top.
b) Connect the speed sensor wire
let/white) of the wire harness to the wire
of the third position from the left side of
the bottom row.
l l REVERSE SENSOR CONNECTION
6. Route the reverse
(red/blue) 13 as shown in the illustra-
tion, and attach the reverse sensor wire
13
using the foam
TNS300
to the wire of the
12 (vio-
sensor wire
8
-b (3x).