Installing The Work Clamp Hinge; Installing The Arm Motor Cover - Brother BAS-364E Instruction Manual

E series programmable electronic pattern sewer
Hide thumbs Also See for BAS-364E:
Table of Contents

Advertisement

Chapter 3 INSTALLATION

4. Installing the work clamp hinge

t
1. Clamp hinge spring (R) e and hinge spring (L) r with the work clamp arm q and work clamp hinge w.
2. After placing the thrust washer y onto Y pulley shaft (A) t, insert Y pulley shaft (A) t into the work clamp arm q
and work clamp hinge w.
Note
Insert Y pulley shaft (A) t into the hole of the work clamp hinge w so that the screw stop u is facing upward.
3. Secure the work clamp hinge w and Y pulley shaft (A) t with the set screw i.
Note
Make sure that the set screw i goes into the screw stop u of Y pulley shaft (A) t.

5. Installing the arm motor cover

q
1. Move the feed mechanism q manually until it is as far into the machine as it will go.
(The ball spline w should be extended fully toward the front when looking from behind the arm.)
2. Aligh the arm motor cover e with the rear of the arm so that there is even clearance between the tube section r
and the ball spline w, and then secure with the accessory screws t.
Note
If noise is heard from the tubular section r of the arm motor cover e while the machine is operating, adjust the
installation position of the arm motor cover e according to the procedure in step 2. above.
5
y
q
u
i
r
BAS-364E, 366E, 370E, 375E
w
i
w
e
u
t
e
w
r
q
y
w
r
t

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bas-366eBas-370eBas-375e

Table of Contents