Connecting Ojo; Charging The Handset - Motorola Ojo User Manual

Connecting Ojo

Connect Ojo as described below:
Power
Connects to Connects to
Phone Jack
Router
1
Turn off the modem and router power.
2
Confirm that your modem is correctly connected to your router.
3
Plug one end of the provided Ethernet cable into the "ROUTER" port on
the back of Ojo and the other end into an open port on the router.
4
Plug one end of the telephone cable into a phone jack and the other end
into the "WALL" port on the back of Ojo.
5
Turn on the power to the modem, wait one minute, and then turn on the
power to the router.
6
Plug one end of the Ojo power cord into the Ojo power block and the
other end into an electrical outlet.
7
Plug the Ojo power block into the "12V" port on the back of Ojo.
Getting Started
4
Getting Started
Ojo powers on, performs a series of self-tests, and displays a series of startup
screens. After a few minutes, the message "Please Call Customer Service" is
displayed.
Note: If you have already registered Ojo and
established an Ojo account, the Ojo Home screen
may be displayed instead of the "Please Call
Customer Service" message.

Charging the Handset

After you've installed the handset battery pack,
place the cordless handset in the handset cradle. An indicator on the handset
screen shows that the handset is charging.
Note: You can register or make a call before the handset is fully charged by
eaving the handset in the cradle. Keep the handset in the cradle to allow the
battery pack to charge fully. It takes approximately 12 hours to charge the
battery pack for the first time.
When the battery pack is fully charged, the handset screen displays a full-
power indicator.
C har gi ng
I ndi cat or
5