Jump-Starting - Skoda 2012 Superb Owner's Manual

Pumping up the tyres
›
Screw the tyre inflation hose
5
tyre valve.
›
Check whether the air release valve
›
Start the engine and run it in idle.
›
Plug the connector 9 into 12 Volt socket
›
Switch on the air compressor with the ON and OFF switch
›
Allow the air compressor to run until a pressure of 2.0 - 2.5 bar is achieved.
Maximum run time of 8 minutes »
›
Switch off the air compressor.
›
If you cannot reach an air pressure of 2.0 – 2.5 bar, unscrew the tyre inflation
hose from the tyre valve.
5
›
Drive the vehicle 10 metres forwards or backwards to allow the sealing agent to
"distribute" in the tyre.
›
Firmly screw the tyre inflation hose
inflation process.
›
If you cannot reach the required tyre inflation pressure here either, this means
the tyre has sustained too much damage. You cannot seal with tyre with the
breakdown kit » .
›
Switch off the air compressor.
›
Remove the tyre inflation hose
5
Once a tyre inflation pressure of 2.0 – 2.5 bar is achieved, continue the journey at
a maximum speed of 80 km/h (50 mph).
Check the tyre inflation pressure after driving for 10 minutes
after driving for 10 minutes.
WARNING
During inflation, the tyre inflation hose and air compressor may get hot- risk
■
of injury!
Do not place the hot tyre inflation hose or hot air compressor on flammable
■
materials - risk of fire!
If you cannot inflate the tyre to at least 2.0 bar, this means the damage sus-
■
tained was too serious. The sealing agent cannot be used to seal the tyre. Do
not drive the vehicle. Get professional assistance!
CAUTION
Switch off the air compressor after running 8 minutes at the latest - danger of
overheating! Allow the air compressor to cool a few minutes before switching it
on again.
» Fig. 180 of the air compressor firmly onto the
is closed.
7
» page 91.
.
8
!
back onto the tyre valve and repeat the
5
from the tyre valve.
» page 209, Check
Check after driving for 10 minutes
ä
First read and observe the introductory information and safety warn-
ings on page 207.
Check the tyre inflation pressure after driving for 10 minutes!
If the tyre inflation pressure is 1.3 bar or less:
›
Do not drive the vehicle! You cannot properly seal with tyre with the break-
down kit.
›
Get professional assistance.
If the tyre inflation pressure is 1.3 bar or more:
›
Adjust the tyre inflation pressure to the correct value (see inside of fuel filler
cap).
›
Continue driving carefully to the nearest specialist garage at a maximum speed
of 80 km/h (50 mph).

Jump-starting

ä
Introduction
This chapter contains information on the following subjects:
Jump-starting
Jump-starting in vehicles with the "START-STOP" system
Jump-starting vehicles with the vehicle battery in the luggage compartment
The battery of another vehicle can be used to jump-start your vehicle if the en-
gine will not start because the battery is flat. Jump-start cables are required for
this purpose.
Both batteries must have a rated voltage of 12 V. The capacity (Ah) of the battery
supplying the power must not be significantly less than the capacity of the dis-
charged battery in your vehicle.
Jump-start cables
Only use jump-start cables which have an adequately large cross-section and in-
sulated terminal clamps. Observe the manufacturer's instructions.
Positive cable - colour coding in the majority of cases is red.
Negative cable - colour coding in the majority of cases is black.


210
211
211
£
209
Do-it-yourself