Instrument Lighting - Skoda Yeti Owner's Manual

The warning light lights up in the instrument cluster when the fog lights are

switched on ⇒ p age 22.
Fog lights with the function "CORNER"
The fog lights with the function "CORNER" are designed for a bet-
ter illumination of the surrounding area near the vehicle when
corning, parking etc.
The fog lights with the function "CORNER" are adjusted according to the steering
angle or after switching on the turn signal light
● the vehicle is stationary and the engine is running or it moves with a speed of
maximum 40 km/h;
● the daylight driving lights are not switched on;
● the low beam is switched on or the light switch is in the position  and the
intensity of the ambient light causes the low beam to be switched on;
● the fog lights are not switched on;
● no reverse gear is engaged.
Note
If you engage the reverse gear during the active function "CORNER", both fog
lights illuminate.
Rear fog light

Switching on the rear fog light
First of all turn the light switch into position  or 
–
Pull the light switch into position
–
The warning light lights up in the instrument cluster when the rear fog light is

switched on ⇒ p age 22.
Only the rear fog light of the trailer lights up if the vehicle has a factory-fitted
towing device or a towing device from ŠKODA original accessories and when you
are towing a trailer which is fitted with the rear fog light.
1)
If both switch on versions are conflicting, for example if the steering wheel is turned to the left and
the right turn signal light is switched on, the turn signal light has the higher priority.
Using the system Safety
1)
in the following circumstances:
⇒ f ig.
26.
.
2
Driving Tips
The rear fog light is located in the rear light array on the driver's side.

CAUTION
The rear fog light should only be switched on if visibility is particularly poor (con-
form with any varying legal provisions) to avoid dazzling vehicles behind your ve-
hicle.
Instrument lighting 
You can adjust the brightness of the instrument lighting.

Instrument lighting


Switch on the light.
–
⇒ f ig. 27
– Turn the control dial
ing.
The illumination intensity of the Information display ⇒ p age 18 is set automatical-
ly. It is only possible to adjust the instrument lighting with the control dial if the
light intensity drops below the set value of the light sensor.
General Maintenance Breakdown assistance
Lights and Visibility
Fig. 27 Dash panel: Instrument lighting
to the desired intensity of the instrument light-
Technical data
49

