Honda Civic Service Manual page 479

Driveline/Axle
6 .
Driveshafts Reassembly (cont'd)
Pack the inboard joint with the joint grease
included in the new driveshaft set.
Grease quantity
Inboard ioint: 130 140 g (4.6-4.9 oz)
Use the grease included in the
inboard boot set.
Fit the inboard joint onto the driveshaft, and note
these items:
. Reinstall the inboard joint onto the driveshaft by
a l i g n i n g t h e m a r k s ( A ) o n t h e i n b o a r d j o i n t a n d
t h e r o l l e r s .
. Hold the driveshaft so the inboard joint is
pointing up to prevent it trom falling off.
7 .
16-12
1 1 .
8 . Make sure the ends of the boot are sealed in the
grooves in the driveshaft and joint, then installthe
boot bands.
. For the double loop type, go to step 12.
(Replacement boot bands only)
. For the low profile type, go to step 9.
Installthe new low profile band {A) onto the boot
{B). then hook the tab (C) of the band,
Close the hook portion of the band (A) with a
commercially available boot band pincers (B), then
hook the tabs of the band.
Install the boot band on the other end of the boot,
and reoeat steos 9 and 10.
9 .
\
1 0 .
I