Manual Transmission
Transmission Reassembly (cont'dl
9 . I n s t a l l t h e 1 4 x 2 0 m m d o w e l p i n s ( A ) .
34 N.m
(3.5 kgf.m,
25 rbf.ft)
Set the tapered cone ring (B) as shown. Place the
transmission housing over the clutch housing,
being careful to line up the shafts.
1 0 .
13-48
11. Lower the transmission housing the rest of the way
as you expand the 72 mm snap ring {C). Release
the snap ring so it seats in the groove of the
countershaft bearing.
12. Check that the 52 mm snap ring is securely seated
in the groove of the countershaft bearing.
Dimension O as instalted: 3.3 6.0 mm
{ 0 . 1 3 0 . 2 4 i n . l
Apply liquid gasket (P/N 08718-0001) to the threads
o f t h e 3 2 m m s e a l i n g c a p { D ) , a n d i n s t a l l i t o n t h e
t r a n s m i s s i o n h o u s i n g ,
I n s t a l l t h e t r a n s m i s s i o n h a n g e r s A . a n d B , a n d t h e
8 mm flange bolts finger-tight.
1 3 .
't4.
1 5 .
8 x 1.25 mm
27 N.m
(2.8 kgf.m.
20 rbf.ft)
(t
\A
e . /
./
Tighten the 8 mm flange bolts in a crisscross
Pattern In several steDs.
(