Bonnet - Ford KA Owner's Handbook Manual

047-068 Ford KA EN:047-063 Ford KA IT
Repositioning the rear seat
Raise the seat backrests and push them
back until hearing the locking click
of both retainers.
Position the seat belt buckles up.
IMPORTANT When returning
the backrest to the position of use,
make sure it is correctly fastened
and you hear the lock click.
Make sure the backrest is properly
secured at both sides to prevent it
moving forward in the event of sharp
braking that may cause injuries
to passengers.
REMOVING THE PARCEL SHELF
To remove the rear shelf, release it from
its two side pins and pull it out.
14-10-2010 11:26 Pagina 49

BONNET

Opening fig. 46-47-48
Proceed as follows:
❒ pull lever A in the direction of
the arrow;
❒ move to the right the lever B
as shown in figure;
❒ lift the bonnet and at the same time
release the support rod C from its
locking device D, then insert the end
of the rod in the seat E of the bonnet
(bigger hole) and push to safety
position (smaller hole), as shown
in figure.
WARNING
The bonnet may drop
suddenly if the supporting
rod is not positioned properly.
Perform these operations when
the car is stationary only.
A
fig. 46
B
fig. 47
KA00038m
KA00039m
49