Ford KA Owner's Handbook Manual page 160

133-146 Ford KA EN:131-148 Ford KA IT
fig. 7
Changing the rear
window wiper blade fig. 7
Proceed as follows:
❒ raise the cover A and remove
the arm from the car, slackening the
nut B that fastens it to the pivot pin;
❒ position the new arm correctly
and tighten the nut;
❒ lower the cover.
14-10-2010 11:41 Pagina 143
KA00200m fig. 8
SPRAY NOZZLES
Windscreen washer fig. 8
If the jet of fluid is inadequate, firstly
check that there is fluid in the reservoir:
see "Checking fluid levels" in this
chapter).
Then check that the nozzle holes
are not clogged, if necessary clean
them using a needle.
The windscreen jets are directed
by adjusting the nozzle angle.
The jets must be directed at about
of the height from the window
upper edge.
WARNING In versions with a sun roof,
make sure that the sun roof is closed
before operating the front jets.
KA00079m
fig. 9
Rear window washer fig. 9
The rear window washer jets are fixed.
The nozzle holder is on the rear window.
1
/
3
KA00080m
143