“Room Controller” “Group Controller” “Zone Manager” The unit can be used with infrared Remote Control, with the Carrier “Room Controller” or “Group Controller” remote control. Some units can be used also with the Carrier “Zone Manager” remote control. Infrared control instructions are contained in the present manual.
40 GKX General information Unit operation and maintenance • Do not open the remote control to avoid possible damage. Read this instruction manual thoroughly before using the unit. In case of malfunction contact a qualified service engineer. • This unit complies with the low-voltage (EEC/73/23) and •...
40 GKX Unit LEDs and controls E N G L I S H NORMAL EMER TEST (M ) Green LED: ON/OFF signal. “Test position”: (it can be activated by opening the control panel). When activated the unit will run in the cooling mode and Yellow LED: timer ON, when illuminated.
40 GKX Before a long shutdown period Optimum comfort... - Correct cleaning - Optimum comfort and minimum power Correct cleaning consumption • Turn the unit OFF and switch the main supply OFF. Keep room temperature at a comfortable level. Use only a clean, damp cloth and a mild detergent.
40 GKX Infrared remote control (if applicable) E N G L I S H Insert the batteries, paying attention to the correct polarity indicated Fix the remote control holder to the wall, using the screw. in the battery compartment; replace the cover.
40 GKX Use of the remote control (if applicable) E N G L I S H Start/stop Temperature control (button B) When the air conditioner is not in operation, the remote control (button E) readout will only display the actual time (if other symbols are...
40 GKX Use of the remote control (if applicable) Combined programming Night stop The combined program (a selection of a sequence of start and (button K) stop times) will start and stop the air conditioner each day at the programmed times, without the need of user intervention. To acti-...
40 GKX Troubleshooting E N G L I S H After inserting the batteries in the remote control, the display interference; avoid sending signals when computers or household does not illuminate: appliances (food processors, coffee makers, etc.) are operating • The batteries are exhausted or the polarity is incorrect; replace close by.
Page 11
L010121H31 - 0398 Via R. Sanzio, 9 - 20058 Villasanta (MI) Italy - Tel. 039/3636.1 The manufacturer reserves the right to change any product specifications without notice. Order No. 14072-74M10, March 1998. Supersedes Order No. 14072-74, January 1998. Printed in Italy...