Rear Panel - JVC RM-HP250DE Instructions Manual

Introduction
Controls, Connectors and Indicators (continued)

Rear panel

RM-HP250AU Rear Panel
TALLY
PGM PVW C
AC ` IN AC120V 60Hz
1 2
RM-HP250DE Rear Panel
TALLY
PGM PVW C
AC ` IN 230V ` 50Hz
1 2
1
[AC ` IN] connector
Connect this socket to a commercial power supply outlet
using the power cord provided.
2
[TALLY] terminals
These terminals input the tally control signals.
REF. : "Tally " on page 14.
3
[INTERCOM] terminals
These terminals input and output the intercom signals.
In a system composed of multiple cameras and remote
control units, the intercom function provides intercommu-
nication between operators.
REF. : "Intercom" on page 14.
4
[AUX VIDEO INPUT] connectors
These connectors are used to input the return video sig-
nal, which returns the SEG (Special Effects Generator) or
switcher output signal to the camera viewfinder.
These two connectors are loop-through connected inside
to enable a bridge connection.
They are terminated automatically when they are not
bridge-connected.
Input VBS or HD component Y signal.
6
INTERCOM
AUX VIDEO INPUT GENLOCK INPUT
H C G
RTS
3 4 5
INTERCOM
AUX VIDEO INPUT GENLOCK INPUT
H C G
3 4 5
VIDEO OUTPUT
Y/G P /B P /R
B R
HD/SD SDI
OUTPUT
COMPOSITE VIDEO
6 7 8
VIDEO OUTPUT INPUT
Y/G P /B P /R
B R
HD/SD SDI
COMPOSITE VIDEO
6 7
5
[GENLOCK INPUT] synchronous signal input
connectors
These connectors are for reference sync signal input.
These two connectors are loop-through connected inside
to enable a bridge connection.
They are terminated automatically when they are not
bridge-connected.
Input BB or Tri-level sync signal.
6
[Y/G, P /B, P /R] component video signal
B R
output connectors
The settings of the output signals from these connectors
can be switched between Y/P
SELECT switch on the connected camera or by using the
menu setup of the camera.
7
[COMPOSITE VIDEO] signal output connector
This connector outputs VBS (composite video) signal.
REMOTE
CAMERA CABLE
9 0
OUTPUT
REMOTE
CAMERA CABLE
8 9 0
/P , G/B/R using the SIG
B R