BW Technologies MicroClip XT Technical Reference Manual page 66

Problem
Detector intermittently enters
alarm without reason.
Features and options are not
operating as expected.
Charging
Battery has been charging for
3+ hours. The charging indicator
on the detector LCD shows the
battery is still charging.
Battery indicator does not display
when charging.
When detector is activated after
charging, the battery indicator does
not display.
Table 14. Troubleshooting
Possible Cause
Ambient gas levels are near alarm setpoint or
the sensor is exposed to a puff of the target
gas
Alarm setpoints defined incorrectly
Detector requires calibration
Missing or faulty sensor(s)
Changes have been made in Fleet Manager II
Battery is trickle charging
Detector is depleted below normal levels
Battery is defective
GasAlertMicroClip XT
Solution
Detector is operating normally. Use caution in
suspect areas. Check the peak (maximum) gas
exposure reading.
Reset alarm setpoints. Refer to
Alarm Setpoints and Sensor
Calibrate the sensors. Refer to Calibration.
Replace the sensor. Refer to
or Sensor Filter.
Verify settings in Fleet Manager II are correct.
Battery is fully charged and ready for operation.
Charge the battery for 8 hours. Detector LEDs
may light during first 5 hours. This is normal. If
the battery indicator does not light after charging
for 8 hours, contact BW Technologies by Honey-
well.
Contact BW Technologies by
Troubleshooting
Factory Gas
Configuration.
Replacing a Sensor
Honeywell.
55