BW Technologies MicroClip XT Technical Reference Manual page 15

GasAlertMicroClip XT
Technical Reference Guide
• For use only in potentially explosive atmospheres where oxygen concentrations do not exceed 20.9% (v/v).
• Any rapid up-scaling reading followed by a declining or erratic reading may indicate a gas concentration beyond upper scale limit,
which may be hazardous.
• Only calibrate the detector in a fresh air environment and in a safe area.
• Use only BW approved batteries for the GasAlertMicroClip XT detector. Refer to Specifications.
• Charge the detector before first-time use. BW recommends the detector be charged after every workday.
• Charge the detector using the recommended charging adapter only. Do not use any other charging adapter. Failure to adhere to this
caution can lead to fire and/or explosion.
• Extended exposure of the detector to certain concentrations of combustible gases and air may stress a detector element that can
seriously affect its performance. If an alarm occurs due to high concentration of combustible gases, calibrate the detector. If necessary,
replace the sensor.
• Do not test the combustible sensor's response with a butane cigarette lighter; doing so will damage the sensor.
• Do not expose the detector to electrical shock and/or severe continuous mechanical shock.
• Do not attempt to disassemble, adjust, or service the detector unless instructions for that procedure are provided in the technical
reference guide, and/or that part is listed as a replacement part. Use only BW Technologies by Honeywell replacement parts. Refer to
Replacement Parts and
• The detector warranty will be voided if customers, personnel, or third parties damage the detector during repair attempts. Non-BW
Technologies by Honeywell repair/service attempts void this warranty.
4
Accessories.
a Cautions