BW Technologies MicroClip XT Technical Reference Manual page 59

GasAlertMicroClip XT
Technical Reference Guide
Table 12. Connecting the Charging Adapter
Item
1 Detector
2 IR and charger interface
3 Charging adapter
4 Charging cable
The detector must be charged in a safe area that is free of
hazardous gas in temperatures of 32°F to 113°F (0°C to 45°C).
1. Deactivate the detector.
2. Plug the charging adapter into an AC outlet.
The charging adapter is voltage specific to your region. Use of
the charging adapter outside your region will damage the
charger and the detector.
3. Attach the charging adapter to the charger interface.
Refer to Figure 10.
4. Allow the battery to charge for 2-3 hours. The charging
indicator flashes on the LCD while the detector is being
charged.
48
Description
a Warning
a Caution
5. When charging is complete, the charging indicator stops
flashing and displays
Remove the charging adapter and activate the detector.
If the battery indicator does not display, refer to Troubleshooting.
6. Charge the battery after each workday.
To reach full battery capacity, allow the battery to fully charge
and fully discharge three times.
Charging the detector in temperatures above 45°F (113°F) will
greatly reduce the number of charges the detector can accept.
The detector may be warm immediately following charging.
This is normal.
to indicate a full charge.
Note