Security (3) - Husqvarna Automower 305 Operator's Manual

Selecting this function causes the mower to travel
directly along the guide wire. If there is a passage
that the mower cannot get through, the settings in
Corridor width (2-1) ought to be changed from Wide
to Medium. If required, the setting can also be
changed to Narrow. The Narrow corridor width setting
should only be used if none of the other settings work
for this installation. When the Test IN function is
activated, the mower travels the farthest distance
from the wire allowed by the selected corridor width.
The figure here shows how Automower
through a passage when Corridor width is set to
Medium and not to Wide.
Test OUT (2-3-2)
The Test OUT (2-3-2) function is used to test exit
settings and to calculate the distance from the
charging station to a remote area.
To test the settings for Remote start (2-2):
Park Automower 305 in the charging station and
®
select Test OUT (2-3-2). The mower will then leave
the charging station straight away along the guide
wire and begin mowing after the designated distance.
To find out the distance from the charging station to a
remote area:
State a distance that easily exceeds the true distance.
The maximum distance that can be stated is
500 metres. Place Automower
station and select Test OUT (2-3-2). The mower will
immediately leave the charging station. The distance
will be shown on the display, stated in metres, as the
mower runs. Stop the mower at the required position
and note the distance. Enter the number of metres
shown in Distance for the area in question.

6.5 Security (3)

Through this selection, settings relating to security
and the connection between the mower and the
charging station can be made.
Change PIN code (3-1)
Enter the new PIN code and press OK. Enter the
same code again and confirm by pressing OK. When
the PIN code is changed, a message stating that the
PIN code has been changed appears in the display
momentarily.
6. MENU FUNCTIONS
305 travels
®
305 in the charging
®
Corridor width
Remote start
Test settings
Timer
Installation
Security
Settings
Test in
Test out
Change PIN code
Security level
New loop signal
English - 41