Charging The Battery - Husqvarna Automower 305 Operator's Manual

Installation and connecting the charging
station
1. Position the charging station in a suitable spot.
2. Attach the charging station to the ground using
the supplied screws.
3. Ensure the screws are secured all the way down
in the countersink.
IMPORTANT INFORMATION
It is not permitted to make new holes in the
plate. Only the existing holes may be used to
secure the plate to the ground.
4. Connect the low voltage cable to the charging
station.
5. Connect the transformer's power cord to a 230V
wall socket. If the wall socket is outdoors, it is
important that the transformer is protected from
direct sunlight.
IMPORTANT INFORMATION
The transformer may not be exposed to direct
sunlight.
IMPORTANT INFORMATION
Do not tread or walk on the charging station
plate.

3.3 Charging the battery

As soon as the charging station is connected, it is
possible to charge the mower.
The mower can be charged as soon as the charging
station is connected. Set the main switch to the
1 position.
Place Automower ® 305 in the charging station to
charge the battery while the boundary and guide
wires are being laid.
If the battery is empty, it takes around 3 hours to fully
charge it.
IMPORTANT INFORMATION
Automower 305 cannot be used before the
®
installation is complete.
18 - English
3. INSTALLATION