How Do I Use The Self-Timer; Let's Talk About Batteries - Vivitar ECam User Manual

How do I Use the Self-Timer?

ECam has a 10-second self-timer. To use this function press
and hold the self-timer button down and then press the shutter
button. This will activate the self-timer LED that will begin to
flash once per second for ten seconds (ten flashes). After the
tenth flash, ECam will take a picture.

Let's Talk about Batteries..........

ECam camera uses a standard 9-volt "transistor radio" battery.
•
Even when ECam is turned OFF, there is a very slight drain
on the batteries. This is required to retain your images that
are in memory If you are not going to use ECam for a while
(days), remove the battery. Removing the battery will make
your battery last longer. It also prevents battery leaks or
corrosion from hurting ECam.
•
Note that if you do remove the battery, all images that are
stored inside ECam will be lost.
•
If the battery goes dead, simply insert a new one, or use an
(optional) AC power supply.
•
If you must dispose of your old batteries, please exercise
environmentally correct means of disposing, or recycling
them.
12