What Do The Sounds Mean - Vivitar ECam User Manual

What do the Sounds Mean?

If you hear this sound -
After ECam is switched on - two
short beeps (high pitch)
After you press the shutter
button - one short beep (high
pitch)
After you press the shutter
button - three short boops (low
pitch)
After one minute where no one
has paid attention to ECam -
two short beeps (high pitch)
After you press the shutter
button - one short beep (high
pitch) followed by four rapid
beeps
After you press the shutter
button with the red LED ON - a
continuous sequence of rapid
beeps
ECam is saying -
ECam is ready to take pictures
ECam has successfully taken a
picture. This is called the
"confirmation tone"
ECam is not ready. Either ECam
needs a little more time, or it is too
dark to take a picture
ECam is bored and wasting
batteries. To save your battery you
should switch ECam off
Memory warning - ECam has taken
21 images and it is close to being
full
Memory is full and you will erase all
24 images if you hold the shutter
down for more than 3 seconds
11