Programming Your Receiver On To The Remote Control - Chamberlain LiftMaster Professional LM1000A Service Training Manual

Programming the Receiver on to the Remote Control
1. Press and hold the button on the remote control.
2. Press and release the PROG button ("Smart" button) on the back of the opener. The light on
the opener flashes once as confirmation.
3. Release the button on the remote control.
4. Finished.
The opener will now operate when the button on the remote control is pressed.
Programming the Remote Control using the Wall-Mounted Multi-Function Door
Control Panel
1. With the door in a closed state, press and hold the button on the remote control.
2. Press and hold the light button on the multi-function door control panel.
3. Continue holding both buttons while you press the push bar on the multi-function door
control panel.
4. Release all the buttons when the opener light flashes once.
5. Finished.
Now the opener will open or close when the button on the remote control is pressed.
Deletion of all Remote Control Codes
Press and hold the "PROG" button ("Smart" button) on the back of the opener until the indicator
light goes out (approx. 6 seconds). All codes previously programmed on to the door opener will
thus be deleted.
Select a button
12
Programming the Receiver
on to the Remote Control
FIGURE 7 Programming the receiver
"Smart" button