Transmission Messages - Chevrolet 2013 Silverado Owner's Manual

Hide thumbs Also See for 2013 Chevrolet Silverado:
Table of Contents

Advertisement

Chevrolet Silverado Owner Manual - 2013 - crc 1st edition - 4/5/12
5-44
Instruments and Controls
See Tire Inspection on page 10 62,
Tire Rotation on page 10 62, Tire
Pressure Monitor System on
page 10 58, and Tire Pressure on
page 10 56 for more information.
TIRE LOW ADD AIR TO TIRE
If the vehicle has the Tire Pressure
Monitor System (TPMS), this
message displays when the
pressure in one or more of the
vehicle's tires is low. This message
also displays LEFT FRT (left front),
RIGHT FRT (right front), LEFT RR
(left rear), or RIGHT RR (right rear)
to indicate the location of the low
tire. The low tire pressure warning
light will also come on. See Tire
Pressure Light on page 5 26. You
can receive more than one tire
pressure message at a time. To
read the other messages that may
have been sent at the same time,
press the set/reset button or the trip
odometer reset stem. If a tire
pressure message appears on the
DIC, stop as soon as you can. Have
the tire pressures checked and set
to those shown on the Tire Loading
Information label. See Tires on
page 10 47, Vehicle Load Limits on
page 9 15, and Tire Pressure on
page 10 56. The DIC also shows
the tire pressure values. See Driver
Information Center (DIC) on
page 5 28.

Transmission Messages

GRADE BRAKING DISABLED
This message displays when the
grade braking has been disabled
with the tow/haul mode button on
the end of the shift lever. See Tow/
Haul Mode on page 9 38, Automatic
Transmission on page 9 33, and
Cruise Control on page 9 59.
GRADE BRAKING ENABLED
This message displays when the
grade braking has been enabled
with the tow/haul mode button on
the end of the shift lever. See Tow/
Haul Mode on page 9 38, Automatic
Transmission on page 9 33, and
Cruise Control on page 9 59.
Black plate (44,1)
GRADE BRAKING ON
This message displays when the
grade braking has been activated
while driving on downhill grades.
This message will only appear the
first time the feature is activated in
an ignition cycle. See Tow/Haul
Mode on page 9 38, Automatic
Transmission on page 9 33, and
Cruise Control on page 9 59.
SERVICE 4 WHEEL DRIVE
If the vehicle has four-wheel drive,
this message may display if a
problem occurs with the
four-wheel-drive system. If this
message appears, stop as soon as
possible and turn off the vehicle.
Make sure the key is in the LOCK/
OFF position for at least one minute
and then restart the vehicle and
check for the message on the DIC
display. If the message is still
displayed or appears again when
you begin driving, the
four-wheel-drive system needs
service. See your dealer.

Advertisement

Table of Contents
loading

Table of Contents