Table of Contents
Advertisement
To enable level2 - WPA-PSK:
1
Select Security Level 2 - WPA-PSK (WPA Personal).
2
In the WPA passphrase box, type a passphrase (also known as Pre-shared key) of your choice. The
passphrase must consist of 8 to 63 ASCII characters or 64 HEX digits.
3
In the Encryption list, click the desired Encryption method (either TKIP or AES).
i
AES is not yet implemented in most wireless stations but AES is already implemented in the
Thomson Gateway.
4
Optionally, select the rekeying interval.
5
In the Version list, click the desired WPA-PSK version.
i
Depending on the WPA-PSK version you choose, one of the following WPA-PSK encryption will
be set automatically:
>
WPA: TKIP
>
WPA2: AES
>
WPA+WPA2: TKIP+AES
Note that AES is not yet implemented in most wireless stations.
6
Click Apply to immediately apply your changes.
7
Configure your wireless station(s) with the same settings.
74
Thomson Gateway Wireless Configuration
Chapter 7
E-DOC-CTC-20060609-0001 v2.0
Hide quick links:
Advertisement
Table of Contents
