Wds With Ap Mode - D-Link DAP-2553 User Manual

Section 3 - Configuration
In WDS with AP mode, the DAP-2553 wirelessly connects
multiple networks while still functioning as a wireless AP.
Wireless Band: Select either 2.4 GHz or 5 GHz from the pull-down
menu.
Mode:
WDS with AP mode is selected from the pull-down
menu.
Network Name
Service Set Identifier (SSID) is the name designated for a
(SSID):
specific wireless local area network (WLAN). The SSID's
factory default setting is dlink. The SSID can be easily
changed to connect to an existing wireless network or to
establish a new wireless network.
SSID Visibility:
Enable or Disable SSID visibility. Enabling this feature
broadcasts the SSID across the network, thus making it
visible to all network users.
Auto Channel
Enabling this feature automatically selects the channel
Selection: that will provide the best wireless performance. This
feature is not supported in WDS with AP mode. The
channel selection process only occurs when the AP is
booting up.
Channel:
All devices on the network must share the same channel. To change the channel, use the pull-down menu to make the
desired selection. (Note: The wireless adapters will automatically scan and match the wireless settings.)
Allows you to select the channel width you would like to operate in. Select 20 MHz if you are not using any 802.11n
Channel Width:
wireless clients. Auto 20/40 MHz allows you to connect to both 802.11n and 802.11b/g or 802.11a wireless devices on your
network.
D-Link DAP-553 User Manual

WDS with AP mode

1