Printer And Pc Connection - Panasonic KX-TD612E Installation Manual

2.4.9 Printer and PC Connection

A user-supplied printer or personal computer (PC) can be connected to the Serial Interface
(RS-232C)(9-pin) on the system. The printer is used to print out the SMDR call records and
system programming data. The PC is used for system programming.
Connect the Serial Interface (RS-232C) connector of the printer or the PC to the Serial
Interface. The cables must be shielded and the maximum length is 2 m.
Arrange the cables so that the printer or the PC will be connected to the system as shown in the
chart on the following page.
• It is possible to perform System Programming using a PC connected to the ISDN extension
port 2 or 3 in place of the Serial Interface (RS-232C). Refer to 2.2.6 ISDN Extension
Connection Structure and 2.2.7 System Programming and Diagnosis with Personal
Computer.
The pin configuration of the Serial Interface (RS-232C) Connector is as follows:
Pin No.
2
3
4
5
6
7
8
Installation Manual
Serial Interface (RS-232C)
(D-SUB, 9-pin)
Printer
Signal Name
RD(RXD) Received Data
SD(TXD) Transmitted Data
ER(DTR) Data Terminal
Ready
SG Signal Ground
DR(DSR) Data Set Ready
RS(RTS) Request To Send
CS(CTS) Clear To Send
or Computer
Circuit Type
EIA CCITT
BB 104
BA 103
CD 108.2
AB 102
CC 107
CA 105
CB 106
Installation
55