Insert Editing; (Insert A Still Image From The Built-In Memory Onto A Tape); Audio Dubbing - JVC GR-SXM536 Instructions Manual

NOTE:
Use the remote control unit to perform the following procedures.
Insert Editing (Insert A Still Image
From The Built-in Memory Onto A
Tape)
You can insert a still image stored in the camcorder's
built-in memory into a previously recorded tape,
replacing a section of the original recording with
minimal picture distortion at the in- and out-points.
The original audio remains unchanged.
Perform steps 1 through 5 in Insert Editing (VIDEO)
( pg. 52) before the following procedure.
1
Press REFRESH for approx. 1 second to select
"DSC". The DSC Lamp comes on. Press REW
or FF to select the still image you wish to insert.
2
To begin Insert Editing, press START/STOP.
When the counter reaches "0:00:00", editing
stops automatically and the camcorder enters
the Insert-Pause mode.
To insert still images in sequential order onto
the tape . . .
... press REW or FF to move the page forward.
To insert still images at random onto the
tape . . .
... first record the still image you selected in
step 1 onto the tape, then press START/
STOP to engage the Insert-Pause mode. To
select another still image, press REW or FF
again, then press START/STOP. Insert Editing
begins.
3
To end Insert Editing, press STOP.
NOTES:
The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
Only video signal is recorded in the Insert Editing
mode.

Audio Dubbing

You can record a new soundtrack on a prerecorded
tape (normal audio only). The sound is recorded from
the built-in microphone.
Perform steps 1, 2 and 3 of the Insert Editing
(VIDEO) procedure (
1
Press REW to go a little beyond the beginning of
the scene onto which you want to dub the new
audio, press PLAY to view the recorded tape,
then press PAUSE at exactly the point where
dubbing should start.
2
Press and hold A. DUB, and without releasing
A. DUB, press and release PAUSE on the
Remote Control. The Audio Dub-Standby mode
is engaged.
3
To begin Audio Dubbing, press PLAY. When the
counter reaches "0:00:00", Audio Dubbing
stops automatically and the camcorder enters
the Audio Dub-Standby mode.
4
To end Audio Dubbing, press STOP.
NOTES:
Do not press FF or REW during Audio Dub-
Standby, or the edit points will not be accurate.
If the microphone is too close to the TV, or if the
TV's volume is too high, whistling or howling may
occur.
NOTES
(for Insert Editing and Audio Dubbing):
Insert Editing and Audio Dubbing may not work
correctly if the tape contains blank segments, or if
the recording speed was changed during the
original recording.
To edit/dub onto a tape, make sure the Erase
Protection tab is in the position that allows
recording. If not, slide the tab. Some cassettes have
removable tabs. If the tab has been removed, cover
the hole with adhesive tape.
Do not press STOP during Insert Editing or Audio
Dubbing, or the edit points will not be accurate.
During Insert Editing and Audio Dubbing, when
Insert-Pause or Audio Dub-Standby is engaged, the
counter may go slightly past "0:00:00". Recording,
however, stops at exactly 0:00:00.
53
EN
pg. 52) before continuing.