Janome Memory Craft 6500 Professional Instruction Book page 17

6
8
9
5
6
5
6
7
8
8
9
9
5
7
7
Threading the Machine
5 Draw the thread down and around the tension
dial from the right to the left. Pull the thread up
to insert it between the tension disks and under
the loop of the check spring.
Be sure that the thread is coming out from
notch of the disk.
5
6
6 Firmly draw the thread up to the take-up lever
and down into its eye from the right to the left,
while holding the thread at the spool.
7
7 Draw the thread down through the lower thread
guide from the right.
8
8 Slip the thread behind the needle bar thread
guide on the left.
9
9 Thread the needle from front to back by hand or
use the automatic needle threader.
16
(continued)
Check Spring
Notch
Eye of the Thread Take-up Lever
Lower Thread Guide
Needle Bar Thread Guide