Changing The Presser Foot; Detaching And Attaching The Foot Holder - Janome Memory Craft 6500 Professional Instruction Book

1
5
4
1
1

Changing the Presser Foot

CAUTION:
Turn OFF the power switch before changing the foot.
Always use the proper foot for the selected pattern. Wrong
2
foot can cause the needle to break.
3
To snap off:
Raise the needle and presser foot.
Press the red button on the back of the foot holder and the
foot will drop.
To snap on:
Place the presser foot so the pin on the foot lies just under
6
the groove of the foot holder.
Lower the foot holder to lock the foot in place.
Each foot is marked with a letter for identification.

Detaching and Attaching the Foot Holder

WARNING:
Turn OFF the power switch before detaching or attaching
2
the foot holder.
To detach:
Raise the presser bar and turn the thumbscrew
counterclockwise to remove the foot holder.
To attach:
3
Align the hole in the foot holder with the threaded hole in
the presser bar and insert the thumbscrew through the
hole.
2
Tighten the thumbscrew by turning it clockwise.
10
1 Red Button
2 Foot Holder
3 Presser Foot
4 Groove
5 Pin
6 Identification Letter
1 Thumbscrew
2 Foot holder
3 Presser Bar