Special Programming - Panasonic KX-TG2711E Operating Instructions Manual

Programming
*7 If you subscribe to a Caller ID service and want to view the caller's information after lifting up
the handset to answer a call, turn off this feature.
*8 If you do not want the unit to ring before the caller information is received, set to "Off".
(Caller ID subscribers only)
You can only remove the first ring if the unit rings two times or more by default, which
depends on your service provider/telephone company.
*9 The recall/flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
*10 To prevent other users from joining your conversations with outside callers, turn this feature
on.

Special programming

Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
R Set the date and time beforehand
(page 15).
1
M N
2
MbN: "Handset Setup" a M
3
MbN: "Alarm" a M
4
MbN: Select the desired alarm option. a
M N
"Off"
Turns alarm off. Go to step 8.
"Once"
An alarm sounds once at the set time.
"Daily"
An alarm sounds daily at the set time.
Go to step 6.
5
Enter the desired date and month.
6
Set the desired time. a M
7
MbN: Select the desired alarm tone. a
M N
R We recommend selecting a different
ringer tone from the one used for
outside calls.
22
TG2711_21E(en)_0725_ver022.pdf TG2711_21E(en)_0725_ver022.pdf
N
N
N
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
22 22
8
M N a M N
R When the alarm is set,
Note:
R To stop the alarm, lift the handset and
press M N or place the handset on the
base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
M N
2
MbN: "Base Unit Setup" a M
3
MbN: "Repeater Mode" a M
4
MbN: Select the desired setting. a
M N a M N
Note:
R After turning the repeater mode on or off,
may flash on the handset momentarily.
2012/07/25 2012/07/25 16:04:13 16:04:13
is displayed.
N
N