Table of Contents
Advertisement
TG6611_6612HK(e-e).book Page 23 Tuesday, May 24, 2011 3:18 PM
Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
L Set the date and time beforehand (page
12).
1
8y72z
2
{r}: Select the desired alarm option. s
M
"Off"
Turns alarm off. Go to step 6.
"Once"
An alarm sounds once at the set time.
"Daily"
An alarm sounds daily at the set time. Go
to step 4.
3
Enter the desired date and month. s
M
4
Set the desired time. s M
5
{r}: Select the desired alarm tone. s
M
L We recommend selecting a different
ringer tone from the one used for
outside calls.
6
M s {ic}
L When the alarm is set, E is displayed.
Note:
L To stop the alarm, press {ic} or place
the handset on the base unit or charger.
L When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Night mode
Night mode allows you to select a period of
time during which the handset will not ring for
outside calls. This feature is useful for time
periods when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set for each handset.
Programming
Important:
L Set the date and time beforehand (page
12).
L If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1
8y238
2
{r}: Select the desired setting. s M
L If you select "Off", press {ic} to
exit.
3
Enter the desired hour and minute you
wish to start this feature. s M
L You can select 24-hour or 12-hour
clock format ("AM" or "PM") by
pressing /.
4
Enter the desired hour and minute you
wish to end this feature. s M
5
{ic}
L When the night mode is set, 3 is
displayed.
Changing the start and end time
1
8y237
2
Continue from step 3, "Turning night
mode on/off", page 23.
Setting the ring delay
This setting allows the handset to ring during
night mode if the caller waits long enough.
After the selected amount of time passes, the
handset rings. If you select "No Ringing",
the handset never rings during night mode.
1
8y239
2
{r}: Select the desired setting. s M
s {ic}
Changing the handset name
Each handset can be given a customised
name ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is "No". If you select
"Yes" without entering any handset name,
"Handset 1" to "Handset 6" is displayed.
23
Advertisement
Table of Contents
