Bowflex MAX Trainer Assembly & Owners Manual page 41

Condition/Problem
Console shuts off (enters sleep
mode) while in use
Pedals will not move
Fan will not turn
Unit rocks/does not sit level
Foot pedals loose/unit difficult
to operate
Replace Chest Strap
Things to Check
Check electrical (wall) outlet
Check connection at front of unit Connection should be secure and undamaged. Replace adapter or connec-
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Check magnet position (requires
shroud removal)
Check Speed Sensor (requires
shroud removal)
Pedal locations
Check for blockage of fan
Check leveler adjustment
Check surface under unit
Hardware
Assembly / Owner's Manual
If interference is eliminated and HR does not function, replace strap.
Make sure unit is plugged into a functioning wall outlet.
tion at unit if either are damaged.
All wires in the cable should be intact. If any are cut or crimped, replace
cable.
Be sure cable is connected securely and oriented properly. Small latch on
connector should line up and snap into place.
Unplug unit from electrical outlet for 5 minutes. Reconnect to outlet.
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to data cable.
Realign sensor if necessary. Replace if there is any damage to the sensor or
the connecting wire.
The Pedals may be "bottomed out". Safely grasp the Static
Handlebars and apply your weight to the heel of the higher foot. While still
grasping the Static Handlebar, lean back slightly applying more weight onto
the heel. Once the Pedals begin to move, resume your intended workout.
Unplug unit from electrical outlet for 5 minutes. Remove material from fan. If
necessary, detach the Shrouds to help with removal. Do not operate machine
until Shrouds have been replaced.
Adjust levelers until machine is level.
Adjustment may not be able to compensate for extremely uneven surfaces.
Move machine to level area.
Tightly secure all hardware on the Pedal Arms and Handlebar Arms.
41
Solution