Setting The Disklavier Control Unit For The Internet Connection - Yamaha DKC-850 Operation Manual

Setting the Disklavier Control Unit for the Internet Connection

[SETUP] "Network"
You can change various settings related to the Internet connection. In most
cases, you do not have to change the default factory settings.
Information:
You can confirm the information of network settings.
Use DHCP:
Select the method to determine several addresses. If your router
has DHCP server function, we recommend that you to select
"DHCP" or "DHCP+DNS."
DNS1/DNS2:
Enter the address of the primary and secondary DNS server. These
settings must be made when Use DHCP is set to "DHCP+DNS" or
"MANUAL."
IPAddr./SubMask/Gateway:
Enter the address of the control unit, subnet mask and gateway
server. These settings must be made when Use DHCP is set to
"MANUAL."
Proxy/Proxy Port:
Enter the name and the port number for the proxy server. These
settings are necessary only when a proxy server is located in your
local network.
1
Press [SETUP] on the remote control.
The setup menu screen appears.
=SETUP MENU=
*TimerPlay
*MIDI
2
Select "Network" with the cursor buttons ([
[ ]), then press [ENTER].
The network setting screen appears.
(1/2)
*AudioI/O
*M-tune
=SETUP MENU= (2/2)
Network Playback
Reset
=Network= -+
Information
>Use DHCP =DHCP
Internet Direct Connection (IDC)
To use the Internet connection,
inquire of your Internet service
provider.
Note:
For information about DNS server
address, IP address, subnet mask
and gateway server address, inquire
of your internet service provider.
] [ ] [ ]
Chapter
5
41