Connecting The Disklavier Control Unit With The Midi Cables - Yamaha DKC-850 Operation Manual

Chapter
2
Getting Started

Connecting the Disklavier Control Unit with the MIDI Cables

Connect the Disklavier control unit to your piano using the MIDI cables.
2, 3
Your control unit
8
Remote control sensor
shielding sticker
Cautions
• Use the Yamaha PJP-PS02/PJP-PS04 adaptor, or an equivalent recommended by Yamaha. Use of
other AC adaptors may result in damage, overheating, or fire.
• Do not stretch the cable or bend its ends.
• Do not attempt to use the cable if it is stretched or if the ends of the cable have been bent. Attempting
to do so may cause interruptions to the power supply.
• Always turn off the main unit power before disconnecting the AC adaptor.
• When you wish to move the Disklavier control unit, unplug the AC adaptor from the AC wall outlet
and disconnect if from the DC-IN 12V connector on the rear panel of the Disklavier control unit before
proceeding.
• Unplug the AC adaptor from the AC wall outlet if you do not intend to use the instrument for an
extended period of time.
10
4
AC adaptor
(PJP-PS02/PJP-PS04)
(supplied)
Your piano
Backing paper
Adhesive tape
Remote control
sensor
Connect monitor speakers.
See page 12.
Disklavier
control unit
MIDI cable (supplied)
Power cable
(supplied)
2, 3
5
6
7