Using The Remote Control - Yamaha DKC-850 Operation Manual

Using the Remote Control

The Disklavier control unit is equipped with a remote control which allows
convenient control from almost anywhere in the room. This section
provides notes on handling the remote control.
■ Installing Batteries in the Remote Control
Before the remote control can be used, the two batteries supplied with the
Disklavier control unit must be installed.
Remove the battery cover from the rear of the remote control, install the
batteries, and then replace the cover.
A diagram inside the battery compartment shows which way the batteries
should be installed. Make sure you insert them correctly.
■ Battery Replacement
When the remote control fails to work from a distance, replace the
batteries.
• Replacement batteries should be UM-3, AA, R6P, or LR6 type.
• Do not use new and old dry batteries together.
• Do not use different types of batteries (alkaline and manganese
batteries, batteries made by different manufacturers or different battery
products made by the same manufacturer) together.
• Remove spent batteries immediately from the remote control.
Otherwise, batteries will overdischarge, causing them to leak electrolyte
or burst which in turn may result in damage to nearby objects or in
burns, injury or other bodily harm.
• Dispose of batteries in accordance with the applicable regulations and
ordinances.
• If the remote control is not to be used for a prolonged period of time,
remove the batteries to prevent possible damage by battery leakage.
• If the batteries have leaked, dispose of them immediately. Avoid
touching the leaked electrolyte or letting it come into contact with skin or
clothing. Clean the battery compartment thoroughly before installing
new batteries.
Getting Started
Important:
Be sure to read the section on
"Handling Batteries" on page iii for
details on the safe handling of dry
batteries.
Chapter
2
13