Suzuki Canvas SQ416 Service Manual page 58

4A2-6 FRONT DRIVE SHAFT / SHAFT BEARING, OIL SEAL
1. Circlip
"A": Fill grease 85 g (3.0 oz)
8) Insert cage into outer race and fit circlip into groove of outer
race.
CAUTION:
Position opening of circlip "a" so that it will not be lined
up with a ball.
9) Apply grease to inside of outer race, and fit boot to outer race.
Fill up inside of boot with joint grease.
"A": Joint Grease 99000-25120
10) Fitting boot to outer race, adjust so that measurements "b" and
"c" become as indicated in figure.
Length "b": 203.2 – 213.2 mm (8.00 – 8.40 in.)
Length "c": 125.5 – 135.5 mm (4.94 – 5.33 in.)
Before fixing boot band, insert screwdriver into boot on joint
side and allow air to enter boot so that air pressure in boot be-
comes the same as atmospheric pressure.
11) Clamp boot band. Check boots for distortion or dent.