Suzuki Canvas SQ416 Service Manual page 20

1. Suction hose
2. Condenser outlet pipe
3. Pipe clamp
INSPECTION
1) Check evaporator fins for blockage. If found clogged, use com-
pressed air to clean the fins.
NOTE:
Do not use water for cleaning of evaporator.
2) Check inlet and outlet fittings for crack or scratch. Repair them
as required.
ASSEMBLY AND INSTALLATION
1) Reverse removal sequence to install evaporator.
2) Enable air bag system. Refer to "Enabling Air Bag System" in
Section 10B.
3) Evacuate and charge system according to previously described
procedure.
EXPANSION VALVE
INSPECTION
Refer to "Troubleshooting Procedure Using Manifold Gauge Set" in
this section.
REMOVAL
1) Recover refrigerant by using recovery and recycling equipment.
Be sure to follow the instruction manual for the equipment. The
amount of compressor oil removed must be measured and the
same amount added to the system.
2) Remove front grill.
3) Disconnect suction pipe, and liquid pipe from evaporator (Cool-
ing unit).
NOTE:
As soon as above hose and pipe are disconnected, cap
opened fittings so that moisture and dust may not enter
cooling unit.
1. Suction pipe
2. Liquid pipe
4) Disconnect suction pipe, and liquid pipe from suction hose and
condenser outlet pipe.
5) Remove pipe clamp then remove suction pipe and liquid pipe.
AIR CONDITIONING (OPTIONAL) 1B-11