Suzuki Canvas SQ416 Service Manual page 31

3B1-4 POWER STEERING (P / S) SYSTEM
(A)
"A"
4) Apply grease to "A" indicated in figure.
5) Position boot properly in grooves of gear case and tie-rod.
Check to ensure that boot is free from twist and dent.
6) Fasten boot with new clamp and clip securely.
Special Tool
(A): 09943-55010
7) Install tie-rod end lock nut and tie-rod end to tie-rod.
Position lock nut to marking made in removal.
NOTE:
When tie-rod was replaced, measure length "A" on re-
moved tie-rod and use it on new replacement tie-rod so as
to position lock nut properly.
8) Install steering gear case. Refer to POWER STEERING GEAR
1
BOX ASSEMBLY INSTALLATION in this section.
1. Mark