a. Connect the power adapter to the access point and plug
the power adapter into an outlet.
b. Wait for the Power LED
amber and turn green.
If no LEDs are lit, press the Power On/Off button on the
rear panel of the access point.
4. Connect a computer.
1
2
3
4
LEDs
The LEDs on the wireless access point light to indicate wireless
access point activity:
LED
Description
•Off. Power is off.
Power
LED
•Green. Power in on.
•Amber. A self-test is running. During startup the LED is amber, then
blinking green before turning steady green after 45 seconds. If the LED is
amber or continues blinking green after one minute, a system fault exists.
Activity
•Off. No ethernet traffic is detected.
LED
•Green or blinking green. Ethernet traffic is detected.
on the front panel to light
4