NETGEAR WAC120 Installation Manual page 12

Problem Cause
You cannot Multiple
configure causes.
the access
point from a
browser.
You cannot A
access the configuration
Internet or problem
the LAN from exists.
a wireless
device.
Possible Solution
•Make sure that the access point is correctly
installed, it is powered on, and the LAN LED is
lit.
•Make sure that your computer is using an
IP address in the same range as the access
point. The access point default IP address is
192.168.0.100, and the default subnet mask is
255.255.255.0.
•Quit the browser, clear the cache, delete the
cookies, and launch the browser again.
•Make sure that the SSID and wireless security
settings of the wireless device are the same as
those of the access point.
•The wireless device might not have the correct
TCP/IP settings to communicate with the
network. Restart the wireless device and check
that TCP/IP is set up correctly for that network.
•The access point default values might not work
with your network. Check the access point
default configuration against the configuration
of other devices in your network. For
information about changing the default values
of the access point, see the reference manual.
9