Dell 5110cn Service Manual page 409

RRP7.3 DEVELOPER ASSEMBLY (Y), (M), (C), (K) (PL7.1.17~20)
Since DEVELOPER ASSEMBLY (Y), (M), (C) and (K) are to be removed in the same
manner, the removal procedure is described for one of them only.
[Removal]
1) Remove TOP COVER FRAME. (RRP1.1)
2) Remove LEFT FRONT COVER. (RRP1.11)
3) Remove LEFT SIDE COVER. (RRP1.12)
4) Remove HIGH VOLTAGE POWER SUPPLY (HVPS). (RRP9.9)
5) Remove DEVELOPER FRAME. (RRP7.1)
Take care not to allow toner to scatter when taking out DEVELOPER ASSEMBLY.
6) Release STOPPER DEVE R and STOPPER DEVE L located on the left and right side of
DEVELOPER FRAME, pull out DEVELOPER ASSEMBLY forward.
[Replacement]
When attaching the new DEVELOPER ASSEMBLY to the printer, peel the SEAL MAG
SIDE L and the SEAL MAG SIDE R from the DEVELOPER ASSEMBLY.
Take care not to attach the DEVELOPER ASSEMBLY of each color to the DEVELOPER
FRAME on the wrong position.
1) Insert DEVELOPER ASSEMBLY into DEVELOPER FRAME and lock STOPPER DEVE R
and STOPPER DEVE L to attach DEVELOPER ASSEMBLY.
2) Attach DEVELOPER FRAME. (RRP7.1)
3) Attach HIGH VOLTAGE POWER SUPPLY (HVPS). (RRP9.9)
4) Attach LEFT SIDE COVER. (RRP1.12)
5) Attach LEFT FRONT COVER. (RRP1.11)
6) Attach TOP COVER FRAME. (RRP1.1)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 159