Dubbing Still Images Recorded On A Tape To A Memory Card - JVC GR-D33 Instructions Manual

Dubbing Still Images Recorded On A Tape
To A Memory Card
Still images can be dubbed from a tape to a memory
card.
1
Load a cassette. ( pg. 10)
2
Load a memory card. (
3
Set the VIDEO/MEMORY Switch to "VIDEO".
4
Set the Power Switch to "PLAY" while pressing down
the Lock Button located on the switch.
5
Set " COPY" to "ON". (
6
Press 4/9 to start playback.
7
At the point you want to dub, press 4/9 again to
engage Still Playback.
8
To dub the image, press SNAPSHOT.
The " " indication appears during dubbing.
The selected image is stored in the memory card.
NOTES:
If SNAPSHOT is pressed in step 8 when a memory card is
not loaded, the message "COPYING FAILED" is displayed.
If an image recorded on the tape using "WIDE MODE"
( pg. 26) is dubbed to a memory card, the WIDE mode
identifying signal is not dubbed with it.
To use Playback Special effects with a video image you
wish to dub, perform up to step 8 using the remote control
(provided). ( pg. 16)
Images are dubbed in 640 x 480 pixels.
pg. 10)
pg. 25, 28)
D.S.C. RECORDING (GR-D93/D73 only)
19
EN