Notes:
1.
2.
Installing a drive: To install an internal drive, follow these steps.
1.
2.
3.
4.
5.
6.
44
IBM : Hardware Maintenance Manual
Drives that are greater than 41.3 mm (1.6 in.) high cannot be installed.
Install removable media (tape or CD) drives in the accessible bay: bay 1 or 2.
Remove the cover. See "Removing the cover" on page 37.
If your computer has a CD drive or DVD drive, you might need to remove the
signal and power cables from the drive.
If the drive you are installing is a removable-media drive, remove the bay panel
from the front bezel.
Remove the metal shield from the drive by inserting a flat–blade screwdriver into
one of the slots and gently prying it loose.
Pivot the drive bay latch handle toward the front of the computer and pivot the
drive bay cage upward, as shown, until it is latched in the upright position.
Make sure the drive that you are installing is set correctly as either a master or a
slave device.