IBM 6343 Hardware Maintenance Manual page 108

100
IBM : Hardware Maintenance Manual
POST Error Code
101XX
Not listed above
10450, 10451, 10490,
10491, 10492, 10499
Read/write error
10452
Seek test error
10453
Wrong drive type?
10454
Sector buffer test error
10455, 10456
Controller error
10459
Drive diagnostic command error
10461
Drive format error
10462
Controller seek error
10464
Hard Drive read error
10467
Drive non-fatal seek error
10468
Drive fatal seek error
10469
Drive soft error count exceeded
10470, 10471, 10472
Controller wrap error
10473
Corrupt data. Low level format might be
required
10480
10481
ESDI drive D seek error
10482
Drive select acknowledgement bad
106X1
10635
10651, 10660
106XX
Not listed above
FRU/Action
1. Modem Adapter/A
2. Data/Fax Modem
3. System Board
4. Riser card
1. Run Enhanced Diagnostics
2. Hard Disk Drive
3. System Board
4. Riser card
1.
Run Enhanced Diagnostics
Information only
1. Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
Information only
1. Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
1.
Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
Information only
1.
Hard Disk Drive (ESDI)
2. Drive Cable
3. System Board
1. Run Enhanced Diagnostics
1. Run Enhanced Diagnostics
1. Check Configuration
2. Ethernet Adapter
1. Power-off computer, wait ten seconds
then power-on the computer
2. Ethernet Adapter
1. Check Cables
2. Ethernet Adapter
1. Ethernet Adapter